Inspections & care
Solar panel removal and reinstall in Pembroke Pines, FL
Your roof needs replacing but solar panels cover a large part of it, and you are not sure who should remove them or how they go back on safely.
- Open 24/7
- Based on Hiatus Road
- HVHZ-rated materials

- Real person on the line
- Visit booked on the same call
- Photos of what we find
Quick answer
Solar panel removal and reinstall means detaching the array, storing and protecting the panels during your reroof, then remounting them on new flashed attachments. You need it whenever the roof under the panels must be replaced or heavily repaired. Electrical disconnect and reconnect are coordinated with your solar company. Typical South Florida cost runs $2,340 to $6,180. Call (754) 226-1055, answered 24/7.
Solar panel removal & reinstall around Pembroke Pines
Solar panels often outlast the roof beneath them, which means many South Florida homeowners will face a reroof with panels in the way. Rooftop arrays are attached through the roof covering with mounts and flashings. When the roof is replaced, those attachments must come off, the new roof goes on underneath, and the mounts are sealed into the new roofing so they do not leak.
In Pembroke Pines, many arrays sit on concrete tile, where mounts need tile hooks or flashing kits made for the tile profile. Poorly sealed mounts are a frequent leak source. Planning the solar removal into the reroof schedule keeps your system offline for the shortest time and makes sure every penetration is flashed correctly into the new underlayment and covering.
When to call
Signs it is time for solar panel removal & reinstall
Reroof due under panels
Your roof is due for replacement or underlayment work and the panels sit over part of the area that needs it.
Leaks below the array
Ceiling stains appear under the array, or water marks show around mount locations when you look from the attic.
Array on aging tile
The panels were installed on an older tile roof that will need its underlayment replaced within the next several years.
Storm damage under panels
A storm cracked tiles or lifted shingles under or near the panels, and repairs cannot be reached with them in place.
Corroded racking
Rails, clamps or mounts show rust or loose bolts, especially on homes closer to the coast where salt air reaches.
System upgrade planned
You plan to expand or replace your solar system and want the roof under it made new at the same time.
How the job runs
What happens on your roof
- 01
Coordinate with solar owner
We contact your solar company or system owner to schedule shutdown, electrical disconnect and any permits the solar work itself requires.
- 02
Detach and label panels
Panels and racking are removed by hand, labeled by position and moved to protected storage on site or at a storage location.
- 03
Reroof the area
The roof under the array is replaced or repaired, including deck work and new underlayment, under the reroof permit and inspections.
- 04
Set new flashed mounts
Mounts are set into the new roof with flashings matched to the tile or shingle and sealed into the underlayment below them.
- 05
Reinstall and reconnect
Racking and panels go back in their original layout, and the solar company completes the electrical reconnection and system checks.

Local factors that change this job
Broward wind requirements apply to rooftop arrays as well as to the roof itself, so mounts and racking must be fastened and flashed using approved methods. Many Pembroke Pines tile roofs carry systems installed in the last decade over underlayment that is already 20 years old or more. Leased systems often require the leasing company to handle disconnection, which affects scheduling. Doing the removal and reroof before hurricane season limits the time the array is down and the roof is open.
Your options
Choices worth understanding first
Remove, store and reinstall
The standard service during a reroof. Panels are removed, stored and remounted on the new roof with new flashed attachments in the same layout.
Partial removal for repair
Only the panels over a damaged section are taken off so the repair can be made, then reinstalled on resealed mounts.
Reinstall in a new layout
If the new roof or a system upgrade calls for a different panel arrangement, the mounts are planned for the new positions during the reroof.
Permanent removal
Panels and racking are taken off for good and every penetration is closed and roofed over, for owners retiring an older system.
Typical cost
What solar panel removal & reinstall costs in Pembroke Pines
| Removal and reinstall, per panel | $115 to $245 |
| New flashed mount on tile, each | $38 to $86 |
| New flashed mount on shingle, each | $24 to $57 |
| Off-site panel storage | $185 to $460 |
The number of panels, roof type and mount style drive most of the cost. Tile roofs need more careful mount work than shingle roofs. Storage away from the home, replacement mounts and electrical work by the solar company add to the total. Reroofing under the array is priced with the roof. The final price is set after an on-roof look at the array. Compare every service on the roofing price guide. Wondering where your roof sits on insurers’ age lists? Try the roof age check.
Questions
Solar panel removal & reinstall questions we hear
Electrical disconnect and reconnection are coordinated with your solar company or system owner, and on leased systems the leasing company may require its own technicians. We schedule around them so panels are removed only after the system is safely shut down, then reinstalled before they reconnect and test it.
Panels are removed by hand, labeled and stored on protected racks with covers, away from foot traffic and roofing debris. We photograph any existing wear or damage before removal so their condition is on record. Careful handling and storage are part of the job from start to finish.
Some racking parts can be reused, but flashings and roof attachments are normally replaced so they seal properly into the new underlayment and covering. On tile roofs, new hooks or flashing kits matched to the tile profile give a much better seal than old mounts reset over new material.
Usually only as long as the reroof under the array takes, plus scheduling time with your solar company for disconnect and reconnect. On a typical home that is often one to two weeks. Afternoon storms and permit inspections can stretch it, so we plan the order of work to keep downtime short.
Related work
Often booked with this service
Roof Replacement
Your roof is aging out, leaks keep coming back after each repair, or your insurer wants proof of remaining roof life before it will renew the policy.
See this serviceConcrete Tile Roofing
Your 1990s tile roof still looks solid from the street, but the underlayment beneath it has dried out and rain is now reaching the deck.
See this serviceTile Underlayment Replacement
Your concrete tiles still look solid, but the felt underneath has dried out and cracked after 20 to 30 years, and new leaks appear with each storm.
See this serviceMore inspections & care services
Where we do this work most
Leak, storm damage or a roof that is simply getting old?
Call the roof line any hour. A real person answers, asks what you are seeing and sets the next step.