Roof repair
Roof truss and rafter repair in Pembroke Pines, FL
Years of slow leaks, a fallen tree or a hurricane can crack or rot the framing under your roof, and new roofing over weak framing will not hold up.
- Open 24/7
- Based on Hiatus Road
- HVHZ-rated materials

- Real person on the line
- Visit booked on the same call
- Photos of what we find
Quick answer
Roof truss and rafter repair restores cracked, rotted or broken framing members that hold up your roof deck. The usual fix is sistering, which fastens new lumber alongside the damaged member, or replacing a section. It is done with the roof opened, often during a reroof, with an engineer letter when required. Typical costs run $780 to $6,940. Call (754) 226-1055, answered 24/7.
Roof truss & rafter repair around Pembroke Pines
Most Pembroke Pines homes are framed with engineered wood trusses, while older homes and additions often use site-built rafters. Both can be damaged by long-running leaks that rot the top chord, by a tree or storm debris that cracks members, or by termites. The damage often stays hidden until the old roof comes off or a ceiling starts to sag.
Framing repair is done with the roof opened, so the damaged members can be seen, measured and reached. Common fixes are sistering new lumber to a weakened rafter or truss chord, adding blocking, or replacing a short section. Engineered trusses should not be cut or altered without a repair design, so when the building department requires it, the repair follows an engineer letter.
When to call
Signs it is time for roof truss & rafter repair
Sagging roof line
A dip along the ridge or between trusses, seen from the street, can mean a cracked or rotted member below the deck.
Dark, soft wood in the attic
Wood that is dark, crumbly or soft at the top of rafters or trusses usually shows rot from a leak that ran for years.
Tree or debris impact
A limb that hit the roof can crack framing even when only a few tiles look broken from the ground.
Cracked or split members
Splits along a rafter or truss chord, often near a knot or a connection, reduce the load the member can carry.
Loose truss plates
Metal plates at truss joints that have pulled out, rusted or bent mean that connection is no longer holding as designed.
Termite signs in the attic
Mud tubes, hollow sounding wood or frass near the framing should be checked by a pest professional, and the damage assessed before reroofing.
How the job runs
What happens on your roof
- 01
Inspect from the attic
We look at the framing from inside where it is reachable, mark damaged members, and photograph cracks, rot and loose plates.
- 02
Open the roof
The roofing and deck over the damaged area come off, or the work is scheduled into your reroof while the deck is exposed.
- 03
Get the repair design
For engineered trusses or major damage, an engineer letter sets the repair method when the building department requires one.
- 04
Sister or replace
New lumber is fastened alongside the damaged member with the specified nails or bolts, or a damaged section is replaced and its connections restored.
- 05
Close up and inspect
New deck is nailed to HVHZ code, the area is dried in, the inspector reviews the repair, and you get photos of the framing work.

Local factors that change this job
Roof framing in Broward and Miami-Dade takes a lot: long afternoon storms that push water through worn underlayment, tree damage when hurricanes topple black olive and ficus trees, and termites that thrive in the humid climate. Concrete tile on many Pembroke Pines homes adds weight, so a weakened truss shows sag sooner. When a reroof is permitted in the HVHZ, damaged framing found under the deck is repaired before new roofing goes on, and the building department may ask for an engineer letter.
Your options
Choices worth understanding first
Sistering
A new piece of lumber fastened along the full damaged length of a rafter or chord. It restores strength without removing the original member.
Section replacement
Cutting out a rotted or broken section and replacing it with new lumber and connectors, used when the damage is localized and access allows.
Engineered truss repair
Repairs to factory trusses follow an engineer's design, often with plywood gussets or added members, so the truss carries its load as intended.
Repair during a reroof
Scheduling framing repair while the old roof is off avoids opening the roof twice and lets damaged deck be replaced in the same visit.
Typical cost
What roof truss & rafter repair costs in Pembroke Pines
| Sister one rafter or truss chord | $780 to $1,640 |
| Each additional member sistered | $310 to $690 |
| Engineer repair letter, when required | $450 to $1,180 |
| Section replacement with roof opened | $2,360 to $6,940 |
Price depends on how many members are damaged, how far rot or cracks run, whether an engineer letter is required, how much roofing and deck must be opened, and attic access. Repairs done during a reroof cost less than opening a sound roof. The final price is set after an on-roof look and given to you in writing. Compare every service on the roofing price guide.
Questions
Roof truss & rafter repair questions we hear
Most cracked or rotted trusses can be repaired in place by sistering new lumber or adding gussets, following an engineer's repair design. Full truss replacement is rare on an occupied home because it means opening a large part of the roof. The method depends on where the damage is and how far it runs.
It depends on the building department and the damage. Simple sistering of a site-built rafter may be accepted under the permit, while repairs to engineered trusses usually need a letter or drawing from an engineer. We check what the department requires and add the letter to the scope when it applies.
Look in the attic for mud tubes on the wood, small holes, piles of droppings that look like sand, or wood that sounds hollow when tapped. A pest professional should confirm and treat active termites. Once that is done, we assess the framing damage and repair the weakened members with the roof opened.
Only if the damage is minor and stable. A rafter with surface rot or a small split may be watched, but a cracked chord, a visible sag or rot that runs deep should be fixed soon, especially before hurricane season. Weak framing also holds deck nails poorly, which matters in high wind.
Related work
Often booked with this service
Roof Deck Replacement
Years of slow leaks have softened the plywood under your roof, so the deck sags between trusses and new roofing cannot be fastened securely to it.
See this serviceHurricane Straps & Roof-to-Wall
If your trusses are held to the walls only by angled toenails or a light clip, strong uplift can pull the whole roof frame off the house.
See this serviceStorm Damage Roof Repair
After a tropical storm passes, damage can hide in plain sight, from loose tile that looks fine from the driveway to underlayment torn where wind got under the edges.
See this serviceMore roof repair services
- Roof Repair
- Leak Repair
- Tile Repair
- Shingle Repair
- Flat Roof Repair
- Metal Roof Repair
- Flashing Repair
- Fascia & Soffit
- Skylights
- Mansard Repair
Where we do this work most
Leak, storm damage or a roof that is simply getting old?
Call the roof line any hour. A real person answers, asks what you are seeing and sets the next step.