Skip to content
Aurora ShieldRoofing Contractors 24/7Call the roof line(754) 226-1055

Hurricane hardening

Rotted roof deck replacement in Pembroke Pines, FL

Years of slow leaks have softened the plywood under your roof, so the deck sags between trusses and new roofing cannot be fastened securely to it.

  • Open 24/7
  • Based on Hiatus Road
  • HVHZ-rated materials
New plywood sheets being installed on a partly stripped roof deck with exposed trusses, South Florida home, concrete tile stacked nearby
Answered 24/7
  • Real person on the line
  • Visit booked on the same call
  • Photos of what we find

Quick answer

Roof deck replacement removes rotted, delaminated or undersized sheathing and installs new plywood nailed to current code. You need it when sheets sag, feel soft or are found damaged after tear-off, and most decks are replaced section by section during a reroof. Typical South Florida cost runs $93 to $157 per sheet, or $4,620 to $11,870 for a full deck. Call (754) 226-1055, answered 24/7.

Roof deck replacement around Pembroke Pines

The roof deck is the base everything else is fastened to. Underlayment nails, tile adhesive and shingle nails all depend on solid wood. When plywood has absorbed water for years, it loses its ability to hold fasteners, and the new roof above it is only as strong as that weakened base. In a hurricane, that is often where failures begin.

In Pembroke Pines, deck damage often hides under tile roofs, where slow leaks around valleys or old skylights rot the wood long before a stain shows on the ceiling. Some older homes also have plank boards or thin sheathing that falls short of HVHZ requirements. Aurora Shield crews find these areas during tear-off and replace them before the new roof goes on.

When to call

Signs it is time for roof deck replacement

Sagging between trusses

From the street or the attic, the roof surface dips in a wave pattern between framing members instead of staying flat.

Soft areas when walked

Some spots give underfoot on the roof, particularly near valleys, chimneys, skylights or air conditioning line penetrations.

Dark stains on sheathing

The underside of the plywood in the attic shows black or brown stains, mold growth or layers flaking apart.

Daylight through the deck

Small points of light show through the sheathing in the attic where the wood has rotted through or split open.

Fasteners will not hold

A roofer reports that nails spin or pull out easily during repairs, a clear sign the wood fibers have broken down.

Plank board sheathing

The roof is decked with spaced boards rather than plywood, which is harder to seal and fasten to current standards.

How the job runs

What happens on your roof

  1. 01

    Map damage from the attic

    We check the underside of the deck with a light and moisture meter to estimate how many sheets are likely to need replacing.

  2. 02

    Cut out failed sheathing

    After tear-off, damaged plywood is cut back to the centers of the nearest trusses so each new sheet has full bearing on framing.

  3. 03

    Inspect the framing

    Exposed trusses are checked for rot or termite damage, and any compromised framing is shown to you before work continues.

  4. 04

    Install new plywood

    New sheathing of the thickness the code requires is laid with expansion gaps between sheets and staggered seams for strength.

  5. 05

    Nail to HVHZ schedule

    Each sheet is fastened with ring-shank nails at the required spacing, then the deck is inspected by the building department before covering.

Close up of a self adhered peel and stick underlayment overlapping on a plywood roof deck
A typical day on a hurricane hardening job in Broward County.

Local factors that change this job

South Florida humidity and long summer rains keep wood damp whenever water gets past the roof covering, so rot spreads faster here than in drier states. Broward HVHZ rules set minimum sheathing thickness and nailing, and the Pembroke Pines building department inspects the deck before it is covered. Drywood termites, common across Broward, can also weaken trusses and fascia near the roof edge. Finding damage during tear-off lets it be fixed before the permit inspection instead of after a failure.

Your options

Choices worth understanding first

Spot sheet replacement

Only the damaged sheets are swapped. Common on tile roofs with one or two old leak areas, and priced per sheet once the deck is exposed.

Partial slope replacement

One full slope of sheathing is replaced where damage is widespread, while sound slopes stay in place and are re-nailed to current spacing.

Full deck replacement

All sheathing is replaced with new plywood. Recommended for plank decks, widespread delamination or roofs that leaked for many years before repair.

Thicker sheathing upgrade

Where the existing deck is thinner than current code, heavier plywood can be installed so it holds fasteners better under hurricane uplift.

Typical cost

What roof deck replacement costs in Pembroke Pines

Typical South Florida range$93 to $157 per sheetor $4,620 to $11,870 for a full deck
Plywood sheet replacement, each$93 to $157
Full deck, average single-story home$4,620 to $8,390
Full deck, larger or two-story home$7,140 to $11,870
Truss or rafter repair, each$185 to $520

The number of sheets replaced is the main factor, and it is only certain once the old roof is off. Framing repairs, plank deck removal and steep pitches add time. We give you a per-sheet price up front so the total does not come as a surprise. The final price is set after an on-roof look and confirmed once the deck is exposed. Compare every service on the roofing price guide. Wondering where your roof sits on insurers’ age lists? Try the roof age check.

Questions

Roof deck replacement questions we hear

We check the attic for stains, delamination and daylight, walk the roof for soft spots, and sometimes use a moisture meter. That gives a good estimate, but hidden damage under tile can only be confirmed once the covering is off. That is why we quote a per-sheet price in advance rather than guessing at a final total.

No. Sagging can come from wet plywood, but also from undersized or damaged trusses, a cracked truss chord or the weight of added roofing layers. We look at both the deck and the framing before recommending a fix, because replacing plywood will not straighten a failing truss.

It should not be. In the HVHZ, underlayment and roof covering must be fastened into solid sheathing, and the building department inspects the deck on a permitted reroof. Roofing over rotted wood leaves fasteners with nothing to grip and is likely to fail inspection or the next strong wind.

We install the sheathing thickness and grade that the code and the roof system approval require for your framing spacing and covering type. Tile roofs carry more weight, so they need sheathing at least as thick as the code minimum, and heavier sheathing is available on request.

Related work

Often booked with this service

Roof Deck Re-Nailing

Older roof decks were often fastened with staples or widely spaced smooth nails, so hurricane suction can lift whole plywood sheets right off the trusses.

See this service

Roof Replacement

Your roof is aging out, leaks keep coming back after each repair, or your insurer wants proof of remaining roof life before it will renew the policy.

See this service

Roof Leak Repair

Water dripping into a bedroom during an afternoon downpour usually enters several feet from the stain, so patching the obvious spot rarely stops the leak for good.

See this service

More hurricane hardening services

Where we do this work most

Leak, storm damage or a roof that is simply getting old?

Call the roof line any hour. A real person answers, asks what you are seeing and sets the next step.

Roof trouble? Answered 24/7Call (754) 226-1055